Structural series 3 of 3.
As you can see I am not going with the offset entrance and glass... because I am looking to make my life easy (since I intend on splitting the structure in two, so that I only have to unwrap 1 side, having the entrance offset would cause all sorts of issues).
Other details.
There are a lot of people who have done various versions of the RA1 war factory, and there are no two that have made the same decisions!
I will be adding the pipes (except the small front right side pipe). I will have the pipes that run along the side of structure go along the entire length and to the rear of the building.
I will also have the iconic, cylinder things, at the front and side of the structure.
The final major decision is.. the rear of the structure. I want the pipes to go into something, but have no interest in making things too complicated (I did this structure because of its simplicity!).
I have seen people have the pipes go directly into the rear of the building, but I would not like the look of that.
When I am low on ideas, I always do something with spinning fans with grates covering them, and a ladder (or two), so that is almost certainly what I will end up doing!
Man, and again, awesome work!